|
|
|
re: PAGE_FAULT_IN_NONPAGED_AREA
Sunday, December 28, 2003 at 12:44 pm Windows 2000 Annoyances Discussion Forum
Posted by Matt C
(6 messages posted)
it the master device on the primary IDE cable, the 2 CD drives are on the secondary
IDE cable.
Its on an 80 wire ribbon cable.
I will check the udma accesss i think its set auto I will see if I can set it to
66
The only other hardware is what I listed in my original message 2 messagesa back.
I have the option in the bios enabled to auto set irq's if it finds a conflict.
On Sunday, December 28, 2003 at 12:19 pm, patrick wrote:
>your motherboard is UDMA/ATA 100 and 13 compatible. that may be causing a problem,
>but not always. the backwards compatability feature may not work with some HDs.
that
>could very well be the problem. also your BIOS may have a setting for this. i know
>i have to set it to either ATA/100 or lower or 100 and higher. also check for any
>assign IRQ options. aand what other hardware do you have installed? do you have
the
>HD as the master drive and the jumpers (if any) set to apprpiate selection?
>
>
|
All messages in this thread [show all]
 |  |  |  |  |  |  |  |  | re: PAGE_FAULT_IN_NONPAGED_AREA (Matt C: Sun, Dec 28, 2003, 12:44 pm) |
| |
| |
Return to the Windows 2000 Discussion Forum
|
|
|
|