re: Stop error 0x0000007B
Saturday, August 22, 2009 at 12:19 pm
Windows 2000 Annoyances Discussion Forum
Posted by druggas
(14 messages posted)
<<2. Ran Repair from install disk - no help>>
Just want to clarify this. Did you use the repair console, or go to setup first and
then do a repair?
Because you will want to boot up with your 2,000 cd and then go to setup and then
do a repair.
I can't imagine that it wouldn't fix your registry and get you up and running without
losing any of your data.
On Saturday, August 22, 2009 at 8:25 am, R. Hinse wrote:
>After registry cleaning (Easy Registry) and defrag (Ausogics) I
>cannot boot Win2K; stop error.
>
>1. I cannot boot into Safe Mode - stop error
>2. Ran Repair from install disk - no help
>3. Ran last known good configuration from advanced menu - no good
>4. Ran chkdsk from Recovery Console - no errors reported
>5. Entered listsvc in Recovery Console to try to identify possible
> bad IDE drivers - only use generic driver; atapi
>6. Enabling boot logging produces no log since the stop error
>apparently occurs before the session manager loads or before
>it reaches the point where the log is written to disk. The stop
>error occurs approximately 50-60% through the Starting Windows
>graphical boot screen.
>7. Also tried fixboot c: and fixmbr in Recovery Console - no help
>
>
>
>I don't think this a hardware error because I can boot into
>Recovery Console without the install disk; it is installed in the
>boot menu. This is probably some sort of registry error but I have
>no way to pinpoint it. A virus is unlikely as I have AVG installed and
>have had no problems.
>
>The following is the listsvc output only for boot or system:
>
>Boot/ System Service Comment
>B ACPI Microsoft ACPI driver
>B AIC78xx
>B AMDAGP AMD 1 G AGP Bus Filter
>S Antiak AK Driver
>B ATAPI Standard IDE/ESDI Hard Disk Controller
>S AvgLdx86 AVG Free Loader Driver x86
>S AvgMfx86 AVG Free On-access Scanner Minifilter Driver x86
>S AvgTdix AVG Free Network Redirector
>S Awlegacy
>S Bantext Belarc SMBios access
>S Beep
>S CdAudio
>S Cdn4_2k
>S CDROM Cd-ROM Driver
>B Diskperf
>B Dmio Logical Disk Manager Driver
>B Dmload
>B Fltmgr
>S Fs-Rec
>B Ftdisk Volume Manager Driver
>B Geruwa
>S i8042prt i8042 Keyboard abd PS/2 Mouse Port Driver
>S InCDPass
>S InCDrec
>S iNCDRM InCD Reader
>B isapnp PnP ISA/EISA Bus Driver
>S Kbdclass Keyboard Class Driver
>S KbdHID Keyboard HID Driver
>B KSecDD
>S lbrtfdc
>S mnmdd
>S Mouclass Mouse Class Driver
>B MountMgr
>S MrxSmb MRXSMB
>B Mup Mup
>B NDIS NDIS System Driver
>S NetBios NetBios Interface
>S NetBT NetBios over TCP/IP
>S Npfs
>B ohci1394 NEC Firewire OHCI Compliant IEEE 1394 Host Controller
>S Parport Parallel Port Driver
>B PantMgr
>B PCI PCI Bus Driver
>S PCIDump
>B PCIIde
>S Rdbss
>S redbook Digital CD Audio Playback Filter Driver
>S PpcSs Remote Procedure Call
>S Serial Serial Port Driver
>S Sfloppy
>S sglfb
>B Snapman Acronis Snapshots Manager
>S Tcpip TCP/IP Protocol Driver
>B Teefer Teefer for NT
>S tga
>S VgaSave
>
>These were listed as disabled but appeared on a list in another
>forum indicating they should be active:
>
>Abiosdsk
>Atdisk
>Fastfat
>BusLogic
>ultra66
>
>I enabled these one at a time but their addition did not fix the
>stop error.
>
>Any further suggestions as to how I might solve this problem
>would be appreciated. I really do not want to reinstall.
- Written in response to:
- Stop error 0x0000007B (R. Hinse: Saturday, August 22, 2009 at 8:25 am)
Responses to this message:
|
|
All messages in this thread [show all]
 |  | re: Stop error 0x0000007B (druggas: Sat, Aug 22, 2009, 12:19 pm) |
| |
| |
Return to the Windows 2000 Discussion Forum
|
|
