|
|
|
cpu running hot
Showing all messages in thread #1116082671 Windows 2000 Annoyances Discussion Forum
The following are all of the messages in this thread (4 in all), shown in chronological order. Click any message subject to view that message by itself or to view the thread hierarchy.
|
cpu running hot
Saturday, May 14, 2005 at 7:57 am Posted by Steve C
(276 messages posted)
I am posting this not as a question but as a question and and answer because I have
already found the problem and wish to pass along the what I found out and how it
got solved. My cpu was running hot, about 168 degrees plus. I have an amd 1.6 ghz
processor and amd runs hot anyway, but not that hot. I tried reinstalling the heatsink
fan with silver paste and all of that, then it would start up cool, get a little
hot and all of a sudden go nuts. Bottom line to this was that the power supply fan
eventually stopped running altogether and the ps was heating up adding heat to the
case, not taking air out, etc. It must have been erratic to cause the cool, then
warm then the out of control type heat. It was only after I was starting to smell
and electrical heatup that I looked and found that the fan was not turning. I had
a spare ps and installed and everything is great. So lesson learned is that an erratic
powers supply fan can come and go and fool you then get worse until you can nail
it down as the culprit. Apparently the fan would run erratically and thus cause the
fluctuations in temps of the cpu, mb, and case. Learn from this one.
Steve C
[Reply or follow-up to this message]
| |
re: Usual giveaway is either more noise or a LOT LESS noise
Saturday, May 14, 2005 at 12:11 pm Posted by Kiwi
(2228 messages posted)
Also more typically for a majority, you don't even know at first that it is heat,
just that the PC shuts down suddenly and you don't know why. When it's a psu fan
going bad, it's typically a bad bearing, and those make a great deal of ugly noise
when they are dying. Of course, my contribution to the thread presupposes that the
user is not hearing- disabled, doesn't it?
Occasionally, a bearing just gradually binds the fan shaft more and more tightly,
so it won't spin up fast enough to cool the psu, let alone to help to exhaust the
PC's heated internal air environment.
.
Kiwi
**
On Saturday, May 14, 2005 at 7:57 am, Steve C wrote:
>... I have already found the problem
[Reply or follow-up to this message]
|
re: Usual giveaway is either more noise or a LOT LESS noise
Saturday, May 14, 2005 at 7:21 pm Posted by Steve C
(276 messages posted)
In this case there was no noise at all and the smell wasn't always there indicating
the complete stoppage of the fan and thus the overheating PS. My guess is that it
was slowing down to a crawl then eventually failing altogether. And my computer did
suddenly go to the BSOD, but not shut down completely. This is the second PS I have
replaced in six months, the other being on my older (3 years old) computer. It too
smelled of electrical burning and indeed it too was the power supply fan had stopped.
I am amazed though at how much the ps fan contributes to the cooling of the case
and cpu or should I say to the contributing of HEAT to the system without the exhaust.
Either way it is a lesson well learned by all. My video card also started acting
erractic, depixilizing, breaking up, etc. So this too would have been something someone
would be puzzled by in trying to figure out whether it was the video card or what.
The only reason I stumbled upon this is that I downloaded a hardware monitoring program
for my son's computer which was shutting down and it showed his temps were okay.
(That turned out to be of all things a defective off/on button). I loaded it onto
my computer and only then did I know my temps were that high. Lesson learned, monitor
your computer. My computer came with a system monitor but I believed I disabled it
for some reason, but I remember it always showed an erratic power fan reading, going
from zero to 25000 rpm. Maybe that's why I disabled it. (duh) It was trying to tell
me something but I had read too many times about unreliable readings and undependable
sensors and chaulked it up to that. Another lesson learned I guess. In summation.....erratic
video card, overheating cpu, BSOD, shutdown, unusual voltage readings (mine was 13.8),
etc. check your power supply.
Steve C
On Saturday, May 14, 2005 at 12:11 pm, Kiwi wrote:
>Also more typically for a majority, you don't even know at first that it is heat,
>just that the PC shuts down suddenly and you don't know why. When it's a psu fan
>going bad, it's typically a bad bearing, and those make a great deal of ugly noise
>when they are dying. Of course, my contribution to the thread presupposes that
the
>user is not hearing- disabled, doesn't it?
>
>Occasionally, a bearing just gradually binds the fan shaft more and more tightly,
>so it won't spin up fast enough to cool the psu, let alone to help to exhaust the
>PC's heated internal air environment.
>
>
>
.
>
>Kiwi
>
>**
>
[Reply or follow-up to this message]
|
re: Usual giveaway is either more noise or a LOT LESS noise
Sunday, May 15, 2005 at 10:15 am Posted by Kiwi
(2228 messages posted)
When cpu's began generating a great deal of heat 3-4 years back (probably a bit longer,
even), I had an AMD Thunderbird (Athlon) 1.33 MHz processor in a mid-tower that seemed
particularly prone to higher temps than I considered good for long life (and I do
keep my PC's for fairly long life cycles); and that was without any overclocking.
I added a separate pair of fans to the case, similar to what a newer case these
days might have.
It has an intake fan in the case side panel, right above the video adapter, and an
exhaust fan in the back panel, just below the psu. The same TBird is still in it,
but is about to retire now. And it did outlive its first psu by at least a year
now.
.
Kiwi
**
On Saturday, May 14, 2005 at 7:21 pm, Steve C wrote:
>In this case there was no noise at all
[Reply or follow-up to this message]
| |
| |
Tip: Use one of the [Reply or follow-up to this message] links above to add a message to this thread
| |
Return to the Windows 2000 Discussion Forum
|
|
|
|