Well, I fixed it the unintuitive way, thanks, anyway!
Tuesday, January 13, 2009 at 9:42 pm
Posted by Kiwi
(2228 messages posted)
Since the PC in question was already connected to the LAN, I hadn't looked inside
of the option to "Connect PC to a network", which is of course where where the choice
of Logon person is made, if you do remember you have to open that dialog box up .
.
.
Kiwi
**
On Tuesday, January 13, 2009 at 1:10 pm, Kiwi wrote:
>There's a fast way to sort out the user names from the RUN command, and I wrote
it
>down somewhere, but I'll be darned if I can recall where! I'm working with an existing
>W2K install on a 120 MB Maxtor Hdd that's been used as a Slave Drive for a couple
>of years, about as long as since I last needed that Run line option.
>
>P.S. It's about time they sorted out the problem in here!
>I tried writing a different question a half dozen times yesterday at two to three
>hour intervals, and did report it to the administration when it first occurred.
[Reply or follow-up to this message]
|
