|
|
|
re: Question about 'Using .CAB Files'
Tuesday, November 5, 2002 at 6:02 am Windows 95 Annoyances Discussion Forum
Posted by Princess2000
(8 messages posted)
I tried using that command, but I get a "Bad command or file name" message. I first
deleted all existing partitions and then created a new one. The boot disk picked
it up and formatted it. I typed in "sys c:" from A:\>
On Monday, November 4, 2002 at 3:42 pm, Steve Easton wrote:
>Aah, Ok. cab files are nothing more than cabinets, or containers of compressed files.
> After you formatted the drive did you re-install the DOS level system files on
the
>hard drive? To make sure, boot with a start up disk and at the A:\> prompt type:
>sys C: and press enter. When it's done, remove the floppy, reboot and try the install
>again.
>
>
|
All messages in this thread [show all]
 |  |  |  |  | re: Question about 'Using .CAB Files' (Princess2000: Tue, Nov 5, 2002, 6:02 am) |
| |
| |
Return to the Windows 95 Discussion Forum
|
|
|
|