|
|
|
re: windows 95 wont start
Wednesday, January 22, 2003 at 3:28 am
Windows 95 Annoyances Discussion Forum
Posted by Steve Easton
(5183 messages posted)
Go to www.95isalive.com and check out the procedures on the Windows Repair page.
On Tuesday, January 21, 2003 at 5:44 pm, ROD wrote:
>I recently bought an older computer. It is a packard bell with windows 95 as its
>operating system. When you turn on the computer it starts to load. When it goes
to
>the loading windows 95 window it wont load. It gives me the error " interface board
>or CD-ROM drive not ready." then goes to "general failure reading drive c:" I have
>tried to go into the computer through safe mode, command prompt only, command prompt
>safe mode previous version of MS DOS. I did this by pressinf f8 when it stated that
>windows 95 was starting. I cant get into the system either way I try. I always get
>the visious circle of general failure reading drive c and then under it I get "
C:\"
>I have a master disc for windows 95 but I cant get it to run. What do I do????
- Written in response to:
- windows 95 wont start (Rod: Tuesday, January 21, 2003 at 5:44 pm)
There are presently no replies to this message.
|
|
All messages in this thread [show all]
 |  | re: windows 95 wont start (Steve Easton: Wed, Jan 22, 2003, 3:28 am) |
| |
| |
Return to the Windows 95 Discussion Forum
|
|
|
|
