|
|
|
re: Question about 'Resolving Hardware Conflicts'
Saturday, November 23, 2002 at 7:02 pm
Windows 98 Annoyances Discussion Forum
Posted by John
(1 messages posted)
If you put your cd burner on the secondary ide"master" or "slave", you need to make
sure the jumper on the cd burner is set for the correct ide!(master) or (slave)
ide cable slave plug master plug
------------------------||---------------------||
look on the back of the cd burner where the ide plugs in, the jumper will be next
to it!
On Tuesday, September 4, 2001 at 1:53 am, amaralliya e. thenardier wrote:
>i had a similar problem a while back. try this: in the properties of the busmaster,
>enable it only on the primary ide channel. reboot, then run hardware detection and
>let it install a standard ide controller. the drive should then appear upon another
>reboot.
|
All messages in this thread [show all]
 |  | question (dave menzies: Thu, Dec 27, 2001, 5:35 am) |
| |  | re: Question about 'Resolving Hardware Conflicts' (John: Sat, Nov 23, 2002, 7:02 pm) |
| |
| |
Return to the Windows 98 Discussion Forum
|
|
|
|
