re: Using CD drive / drivers in DOS Monday, December 2, 2002 at 4:55 pm Windows 98 Annoyances Discussion Forum Posted by Yann (12 messages posted) Thank you all for your replies. I have solved this problem… by accident, today. I noticed that there were some SYS drivers in the EBD folder, and one of them works fine. So, the syntax reads as follow : DeviceHigh=c:\Windows\Command\Ebd\Oakcdrom.sys /d:Mscd001. Concerning the Himem and Emm386 statements, I still mention those (in the CONFIG.SYS on my boot disk), just to make sure that DOS is loaded into HM, to free at least 600k of conventional memory, since many DOS programs require at least 600k of conventional memory to run. Thanks again. Written in response to: re: Using CD drive / drivers in DOS (Oh_dear: Monday, December 2, 2002 at 12:26 pm) There are presently no replies to this message. All messages in this thread [show all] Using CD drive / drivers in DOS (Yann: Sun, Dec 1, 2002, 9:35 pm) re: Using CD drive / drivers in DOS (Dale: Sun, Dec 1, 2002, 10:47 pm) re: Using CD drive / drivers in DOS (jmb: Mon, Dec 2, 2002, 1:56 am) re: Using CD drive / drivers in DOS (Michael: Mon, Dec 2, 2002, 4:39 am) re: Using CD drive / drivers in DOS (Oh_dear: Mon, Dec 2, 2002, 11:40 am) re: Using CD drive / drivers in DOS (Michael: Mon, Dec 2, 2002, 11:54 am) re: Using CD drive / drivers in DOS (Oh_dear: Mon, Dec 2, 2002, 12:26 pm) re: Using CD drive / drivers in DOS (Yann: Mon, Dec 2, 2002, 4:55 pm) re: Using CD drive / drivers in DOS (Michael: Thu, Dec 5, 2002, 5:52 am) re: Using CD drive / drivers in DOS (Oh_dear: Thu, Dec 5, 2002, 8:34 am) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows 98 Discussion Forum