re: getting ready to install 2nd HD, lost CD ROM and CD/RW Friday, December 19, 2003 at 7:53 pm Windows 98 Annoyances Discussion Forum Posted by Randy (1 messages posted) Yes, I set the jumpers on each drive as is appropriate to its position. I checked for correct cable orientation and that was as it should be. On Friday, December 19, 2003 at 5:17 pm, carl wrote: >Also check that red edge of the ribbon cable is on pin1 on both the hard drive and >the motherboard when you attach the cable. > > Written in response to: re: getting ready to install 2nd HD, lost CD ROM and CD/RW (carl: Friday, December 19, 2003 at 5:17 pm) There are presently no replies to this message. All messages in this thread [show all] getting ready to install 2nd HD, lost CD ROM and CD/RW (Randy: Fri, Dec 19, 2003, 12:55 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (carl: Fri, Dec 19, 2003, 5:14 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (carl: Fri, Dec 19, 2003, 5:17 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (Randy: Fri, Dec 19, 2003, 7:53 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (Gerry Kroll: Fri, Dec 19, 2003, 6:35 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (Randy: Fri, Dec 19, 2003, 7:57 pm) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (Gerry Kroll: Sat, Dec 20, 2003, 6:27 am) re: getting ready to install 2nd HD, lost CD ROM and CD/RW (Randy: Sat, Dec 20, 2003, 8:22 am) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows 98 Discussion Forum