This is the correct spec for your system and it is double sided LD.  This is a 256 
module:

http://www.crucial.com/store/MPartspecs.Asp?mtbpoid=1FD50B59A5CA7304&WSMD=Pavilion+8750C&WSPN=CT187297#info

When you take the new module back, make sure this is the spec you get.  If they can't 
verify what they are selling you, go some place that can.  Note, in the above page 
link two of the spec listings.  CL-2 and the 32 X 64..  The 64 number can NOT be 
any higher.  If it is, it's wrong for your computer.  Also check HP's website that 
no BIOS update is necessary to run the full capacity of RAM.  Sometimes the BIOS 
needed to be upgraded for early versions of the same computer model series.  Good 
Luck!!   :-)







On Thursday, September 8, 2005 at 8:21 pm, Loc Long wrote:

>I have an HP 8750C Pavilion, 667Mhz running WIN98 with original 64M of SDRAM.  Phoenix 

>BIOS version 1.10

>

>I have just purchased a new memory stick and installed it in second bank. At boot-up 

>the system returns the above error . The system does recognize the new extended 
SDRAM 

>and new the total installed memory for banks

>

>The new SDRAM is PC133 256M though

>

>Can I run mix speed memory sticks on this HP ?

>The computer specs said it supports both speed.  The sale guy said it "should" work 

>!

>

>When I put the new stick in slot 1, it failed to boot completely. Does this mean 

>I have a bad memory stick ?.. It is brand new.

>

>Any suggestions ?

>

>Thanks for your help

>

>Loc 

• Reply or follow-up to this message

• Search this forum
• Start a new thread on a different subject

• Report abuse of the forum