re: Question about 'Use Quick View with Any File' Tuesday, October 11, 2005 at 1:21 pm Windows 98 Annoyances Discussion Forum Posted by Vernon (2 messages posted) I have developed a program for handicapping. However, rather than input the data manually, I have subscribed to a service which has the data in raw format which, if I can open the file (I was given the layout), then I can automatically retrieve just the data that I need for my calculations. Using Quick View, I am able to view the raw data, but when I try to open same I fail. I have tried C:\...\...\filename in the address bar, but get a message that access is denied. I have spoken with their tech people and they stated that I must open it using my program, but that is where I am lost. I hope this helps you, and you can give me a command that I can use in my code to open the file. Thanks, Vernon On Tuesday, October 11, 2005 at 1:16 pm, KeithT wrote: >What you are trying to achieve is not clear.......to me anyway. > > Written in response to: re: Question about 'Use Quick View with Any File' (KeithT: Tuesday, October 11, 2005 at 1:16 pm) Responses to this message: re: Question about 'Use Quick View with Any File' (KeithT: Tuesday, October 11, 2005 at 2:41 pm) re: Question about 'Use Quick View with Any File' (normanw: Tuesday, October 11, 2005 at 5:37 pm) All messages in this thread [show all] Question about 'Use Quick View with Any File' (Vernon: Tue, Oct 11, 2005, 4:42 am) re: Question about 'Use Quick View with Any File' (KeithT: Tue, Oct 11, 2005, 1:16 pm) re: Question about 'Use Quick View with Any File' (Vernon: Tue, Oct 11, 2005, 1:21 pm) re: Question about 'Use Quick View with Any File' (KeithT: Tue, Oct 11, 2005, 2:41 pm) re: Question about 'Use Quick View with Any File' (normanw: Tue, Oct 11, 2005, 5:37 pm) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows 98 Discussion Forum