re: Switching IDE Master and Slave HDD's Tuesday, March 14, 2006 at 5:33 am Windows 98 Annoyances Discussion Forum Posted by JasperT2 (28 messages posted) This Question does not belong on this forum. This in not a Win 98 question and should not have been posted here. While we all like to help - this is the wrong place for this question. It belongs in a hardware or troubleshooting forum. On Monday, March 13, 2006 at 1:10 pm, andrew wrote: >My computer has 2 HDD's, one Primary IDE Master, and one Primary IDE Slave. What >i'm trying to do is switch which HDD the computer recognizes as the Master and which >is recognized at the Slave. The problem I'm having is that when I opened up the >computer, the Master drives jumper was set to "Master", but the Slave drives jumper >was set to Cable set. What would I do to make the Master HDD the Slave and the Slave >HDD the Master (i.e. where would I set the jumpers, which IDE's would I use, etc)? > Written in response to: Switching IDE Master and Slave HDD's (andrew: Monday, March 13, 2006 at 1:10 pm) There are presently no replies to this message. All messages in this thread [show all] Switching IDE Master and Slave HDD's (andrew: Mon, Mar 13, 2006, 1:10 pm) re: Switching IDE Master and Slave HDD's (Kiwi: Mon, Mar 13, 2006, 2:52 pm) re: Switching IDE Master and Slave HDD's (andrew: Mon, Mar 13, 2006, 5:55 pm) re: Switching IDE Master and Slave HDD's (bob wells: Mon, Mar 13, 2006, 4:24 pm) re: Switching IDE Master and Slave HDD's (andrew: Mon, Mar 13, 2006, 6:04 pm) re: Switching IDE Master and Slave HDD's (bob wells: Mon, Mar 13, 2006, 10:29 pm) re: Switching IDE Master and Slave HDD's (JasperT2: Tue, Mar 14, 2006, 5:33 am) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows 98 Discussion Forum