|
|
|
HP C6280 all-in-one printer
Showing all messages in thread #1238794104
Windows 98 Annoyances Discussion Forum
The following are all of the messages in this thread (4 in all), shown in chronological order. Click any message subject to view that message by itself or to view the thread hierarchy.
|
HP C6280 all-in-one printer
Friday, April 3, 2009 at 2:28 pm
Posted by Laura
(1 messages posted)
The printer will not feed paper. either to make a copy or from the computer. It
will say it is printing, and then stops and says that I should put paper in tray
face down. So I do.. no luck..then I turn paper over.. and it does the same thing.
I unplugged it for a while, didn't help. What is next?
[Reply or follow-up to this message]
| |
[Printer won't feed paper]
Friday, April 3, 2009 at 4:59 pm
Posted by gewg_
(4444 messages posted)
Laura wrote:
|The printer will not feed paper. either to make a copy or from the computer.
|It will say it is printing, and then stops
|and says that I should put paper in tray face down. So I do.. no luck[...]
It could be that the printer is simply in need of repair/replacement.
What is within *your* power to do is to
go into Control Panel and Remove the existing device driver for that peripheral
then reinstall the driver and reboot the computer.
You need the disk that came with the printer--or even better,
go to the manufacturer's site and get the most recent version of their W98 driver.
**What is a device driver**
http://www.karlsforums.com/faq/faq_devicedriver.htm
[Reply or follow-up to this message]
|
re: HP C6280 all-in-one printer
Friday, April 3, 2009 at 8:57 pm
Posted by C K
(6910 messages posted)
Sensor issues.. The printer is bad generally.. Contact HP, but if out of warranty,
it is more expensive to repair than replace, if it can be repaired. Just depends
on how old it is..
Check HP's website for troubleshooting procedures if you don't have the manual..
[Reply or follow-up to this message]
|
re: HP C6280 all-in-one printer
Saturday, April 4, 2009 at 2:15 pm
Posted by ancien
(61 messages posted)
Unplug it and turn it upside down to see if a pencil or a paperclip fell in the chute.
Look very carefully for any obstruction, like a little crumpled piece of paper or
a label stcuck to a roller or a staple.
On Friday, April 3, 2009 at 2:28 pm, Laura wrote:
>The printer will not feed paper. either to make a copy or from the computer. It
>will say it is printing, and then stops and says that I should put paper in tray
>face down. So I do.. no luck..then I turn paper over.. and it does the same thing.
> I unplugged it for a while, didn't help. What is next?
[Reply or follow-up to this message]
| |
| |
Tip: Use one of the [Reply or follow-up to this message] links above to add a message to this thread
| |
Return to the Windows 98 Discussion Forum
|
|
|
|
