re: help needed to install more memory
Thursday, March 3, 2005 at 9:21 am
Windows Me Annoyances Discussion Forum
Posted by Rose Q
(59 messages posted)
Thanks Jack,
I was hoping you would be around to help me, helpful as usual, i found the copaq
site you sent me, and many others, have searched anything i could find before i asked
for help but did'nt realise it would be in a covered area ,was to scared to remove
any covering, just to let you know since you last helped me touch wood everything
as been a1, i know it's an old crock but a lifeline to me, so thought i would try
to give it a boost , hard to get the memory part but now i have and hope to get it
installed thanks for your help much appreciated.
Regards Rose
On Wednesday, March 2, 2005 at 5:56 pm, Jack Gulley wrote:
>Hi Rose.
> Glad to see you are finally trying to add some memory to that old box. It will
>make a difference in how long it takes to boot up the system and do things.
> You needed to look around on some of the other web pages related to that link
>to the Compaq site. All the information is there, if you look long enough.
> The one you need for the memory module plugging is:
> Memory
>Socket and Memory Module
> Looking from the back of the system, it should be just behind where the printer
>plug (wide plug) is and to the right. When you plug the module in, note the position
>of the two "slots" in the edge of the module, and line them up with the guide inside
>the socket. It can only go one way. Be sure to push the locking tabs on each end
>back, they should both snap up into place as the module is pushed in, and lock into
>the notch on each end of the module.
> However, the reason you can not see it is because it is under a Air Baffle cover
>attached to the power supply box.
> Lift
>Air Baffle up
> You have to lift it up from the right edge. (Looking from the back, the edge
you
>lift will be near the center of the box near the back.
|
All messages in this thread [show all]
 | |  | re: help needed to install more memory (Rose Q: Thu, Mar 3, 2005, 9:21 am) |
| |
| |
| |
Return to the Windows Me Discussion Forum
|
|
