|
|
|
re: Adding Memory to Win ME
Friday, December 21, 2007 at 9:19 am
Windows Me Annoyances Discussion Forum
Posted by sean97
(33 messages posted)
I run WinME with 756mb. The only requirement I know of for this to work properly
is described at
http://users.adelphia.net/~jgulley/me/index.html
where Gulley gives the system.ini change needed.
On Thursday, December 20, 2007 at 8:01 pm, C K wrote:
>ECC and non ECC will NOT mix. ECC is used in servers and/or high end machines where
>data integraty is the utmost importance. Yours has NON ECC memory if it has the
>factory spec modules.
>
>RD RAM is very particular. When it was relaesed, there were many issues due to
it's
>design and speed. I tried mixing speeds of memory but the machines would fail or
>throw data errors constantly. Your luck may be better. With typical SD RAM, adding
>a faster speed ram would simply slow down the faster modules to work with slower
>ones. For RD RAM, make sure you buy compatible/recommended RAM or you may have
problems
>and might be a waste of money if you can't return them.
>
>Win 98/SE/ME has a design limit for the memory it can effectively use. Adding more
>than 512 meg, won't see much difference if any difference, and you have to add some
>tweaks or you will have out of memory/low resource errors. Best bet is to stay
at
>512 meg of RAM.
>
>
>
|
All messages in this thread [show all]
 | | | |  | re: Adding Memory to Win ME (sean97: Fri, Dec 21, 2007, 9:19 am) |
| |
| |
Return to the Windows Me Discussion Forum
|
|
|
|
