Question about 'Resolving Hardware Conflicts'
Thursday, September 19, 2002 at 4:30 pm
Posted by Tristan
(1 messages posted)
I have a question about Resolving
Hardware Conflicts:
Last December, I bought a new DVD player from H-Val to put into my Dell computer.
The handbook says to put the jumpers on the back to the master position. So, I
do this and I get a hardware conflict with the Ultra ATA controller. So then I try
to put the jumpers in one of the others (Slave or CS) and the computer does not recognize
either the DVd or the CdRW drive.
So then I look in the IRQ's and the DVD and the ATA are both using the same IRQ's.
Everything works fine on my computer and I can watch DVD's but the problem is just
annoying. Can anyone help?
[Reply or follow-up to this message]
|
