re: canon bjc 2100 used ink tank is full?
Tuesday, March 27, 2007 at 10:07 pm
Posted by dougdeep
(14 messages posted)
You can find a lot of information on printers at the www.fixyourownprinter.com user
forums. I didn't see the exact same BJC 2100 mentioned but a search of "canon ink
tank full" turned up the following procedure for several models of Canon inkjet printers:
(1) Turn off the printer.
(2) Press and hold the RESUME button, then press and hold the POWER button.
(3) Release the RESUME button, Next press and release the RESUME button two(2) more
times in succession. Note: you are still holding the POWER button).
(4) Release the POWER button.
The printer's carriage will “reset" or move momentarily.
If the above was properly performed the printer will enter the "Service Mode".
(5) Press the RESUME button 4 times, this will select the clear waste ink counter
function. The lamp will alternate (change) color with each key press.
(6) Press the POWER button to "set" the change.
(7) Press the POWER button again to restart the printer.
Check the forum to find out what the "tank" really is. Good luck.
[Reply or follow-up to this message]
|
