Ram issue Wednesday, August 12, 2009 at 12:08 pm Windows Vista Annoyances Discussion Forum Posted by james (12 messages posted) have this board and slight annoyance thats driving me nuts. Its the ram when one stick is inserted the ddr2 fsb is 800mhz. When i put more than one stick in it downgrades it to 667. I have gone into the board bios and there is no way of setting the dram fsb manually. I have also played around with the voltages nothing makes any changes. Also did a snapshot of the ram latency in cpuz with just one stick and then 2. The clocks are exactly the same 5-5-5-20. Although with one stick when the computer is used the fsb jumps to 400 then goes back down to 200. Also tried these stick in an asrock board which can manually set the fsb for dram and it worked and booted fine at 800mhz. Can anyone elaborate on what might me the problem as am about to pull my hair out. Responses to this message: re: Ram issue (Steve: Wednesday, August 12, 2009 at 1:40 pm) re: Ram issue (Charlie Hadden: Thursday, August 13, 2009 at 5:55 am) re: Ram issue (sean: Tuesday, August 25, 2009 at 10:04 pm) All messages in this thread [show all] Ram issue (james: Wed, Aug 12, 2009, 12:08 pm) re: Ram issue (Steve: Wed, Aug 12, 2009, 1:40 pm) re: Ram issue (Charlie Hadden: Thu, Aug 13, 2009, 5:55 am) re: Ram issue (sean: Tue, Aug 25, 2009, 10:04 pm) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows Vista Discussion Forum