re: Ram issue
Tuesday, August 25, 2009 at 10:04 pm
Windows Vista Annoyances Discussion Forum
Posted by sean
(342 messages posted)
I had to set the bus speed and timings manually to get the advertised speeds. Play
with them a bit and see what u get.
On Wednesday, August 12, 2009 at 12:08 pm, james wrote:
>have this board and slight annoyance thats driving me nuts. Its the ram when one
>stick is inserted the ddr2 fsb is 800mhz. When i put more than one stick in it downgrades
>it to 667. I have gone into the board bios and there is no way of setting the dram
>fsb manually. I have also played around with the voltages nothing makes any changes.
>Also did a snapshot of the ram latency in cpuz with just one stick and then 2. The
>clocks are exactly the same 5-5-5-20. Although with one stick when the computer
is
>used the fsb jumps to 400 then goes back down to 200. Also tried these stick in
an
>asrock board which can manually set the fsb for dram and it worked and booted fine
>at 800mhz. Can anyone elaborate on what might me the problem as am about to pull
>my hair out.
- Written in response to:
- Ram issue (james: Wednesday, August 12, 2009 at 12:08 pm)
There are presently no replies to this message.
|
|
All messages in this thread [show all]
 | Ram issue (james: Wed, Aug 12, 2009, 12:08 pm) |
 |  | re: Ram issue (sean: Tue, Aug 25, 2009, 10:04 pm) |
| |
| |
| |
Return to the Windows Vista Discussion Forum
|
|
