re: cd burner not detected in xp pro
Thursday, January 16, 2003 at 9:49 pm
Windows XP Annoyances Discussion Forum
Posted by Casey
(571 messages posted)
Hi again , i'm runnin short of ideas i found this page from the people who make the
atapi controller that is in the burner case , you can look and see if there's anything
there that HP didn't mention on their site http://www.scmmicro.com/faq.html?PID=31&s1=8&s2=52#Parallel%20Port
another thing to maybe look at is in device manager under properties for the parallel
port , maybe try checking the box to always use an interrupt (IRQ) , i've never had
to use this in XP so i'm not sure of any side effects that may have, the P port needs
IRQ 7 , probably more for an older device like this than newer stuff (printers etc),
as far as getting rid of the "send to" lag , go to c:\documents and settings\(username)\send
to and delete the entry for the burner (send to is a hidden folder set prefs to
show hidden files/folders)
i'll keep thinking about this and if i think of anything else i'll post back. Case
On Thursday, January 16, 2003 at 8:25 pm, Tiffany wrote:
>
>Hi Casey,
>I'm using the HP Record Now software. I have the EZCD but found out before hand
that
>it might cause conflicts so I downloaded the other instead. I also tried what you
>suggested, still no improvements, though.
>Tiffany
>
|
All messages in this thread [show all]
 |  | | | |  | re: cd burner not detected in xp pro (Casey: Thu, Jan 16, 2003, 9:49 pm) |
| |
| |
| |
Return to the Windows XP Discussion Forum
|
|
