re: Hard Drive Flamed!
Monday, April 7, 2003 at 9:45 am
Windows XP Annoyances Discussion Forum
Posted by Ricer46
(21956 messages posted)
"do the Jumpers have to be changed on the optical drives as well as the HD's?"
Assuming a CD drive was not on the same cable with the hard drive to start (which
it should not have been) - NO.
"If so, can someone list the Jumper settings for me. I have a CD ROM, CDRW"
jumper settings are almost always written on the drives. If not, there is no absolute
standard for these, you can get the information from the manufacturer's web page.
On Monday, April 7, 2003 at 8:55 am, surfrider wrote:
>Hey thanks for the quick response. Now try this one on for size! LOL, last night
>before my HD flamed, I was attempting to install another HD for data storage only.
>Well it installed fine, but then I noticed that my cd rom and cdrw Icons were "gone"
>in "my computer". My question is, when installing an addtional HD, do the Jumpers
>have to be changed on the optical drives as well as the HD's? If so, can someone
>list the Jumper settings for me. I have a CD ROM, CDRW, 1 Regular HD, and I want
>to add an additional HD for storage. I only have one data cable for my HD's, which
>plug goes in which HD? Im assuming HD0 in the Master and HD1 in the slave? Thanks
>again.
>
- Written in response to:
- re: Hard Drive Flamed! (surfrider: Monday, April 7, 2003 at 8:55 am)
There are presently no replies to this message.
|
|
All messages in this thread [show all]
 |  | |  | re: Hard Drive Flamed! (Ricer46: Mon, Apr 7, 2003, 9:45 am) |
|
