re: Mup.sys? Hangs but not? Wha's happening?
Friday, January 23, 2004 at 8:30 pm
Windows XP Annoyances Discussion Forum
Posted by SomeGuy
(2 messages posted)
updating my own problem:
As someone had suggested earlier I had set my bios back to defaults, which disabled
my USB support. I turned that back on, and now have USB again. So, basically, Daemon
Tools was the problem which was making Mup.sys 'stall'. So, I'd check any recently
installed programs that have something installing right after mup.sys and remove
those.
On Friday, January 23, 2004 at 7:58 pm, SomeGuy wrote:
>
>I don't know if anyone of you had just installed Daemon Tools but that is what I
>had installed and then I ran into this lovely mup.sys lockup. When I would run
XP
>in safemode I saw that after mup.sys loaded I was given the option of letting d344bus.sys
>install or escaping past it. The only way I could get into safe mode was to use
>the escape key to bypass that install, and then I could get in. So I went into
the
>recovery console and disabled d344bus.sys and I was once again able to run Windows
>normally. Well, almost normally because now I have no USB support at all. Doesn't
>detect any of my devices, so I need to figure out how to reinstall those. But I
>was able to get past mup.sys!!!! So, if any of you have recently installed daemon
>tools this might be your problem. (this is Daemon Tools 3.44)
>
|
All messages in this thread [show all]
 |  | |  | re: Mup.sys? Hangs but not? Wha's happening? (SomeGuy: Fri, Jan 23, 2004, 8:30 pm) |
| |
