re: Modem canot start (Code 10) Saturday, April 3, 2004 at 12:05 pm Windows XP Annoyances Discussion Forum Posted by triplate (20746 messages posted) You did install the correct driver for it??...you may have an IRQ conflict, but i doubt it...you could try removing and reinstalling your PCI cards, one at a time, rebooting between...start with your modem...see what happens..;) On Saturday, April 3, 2004 at 11:16 am, John McMurtry wrote: >I have just done a new install of XP on a blank Hard Drive. All is well except the >modem which will not work. In Device Manger it shows it has a problem with the "!" >in a yellow diamond next to the item. Checking the properties, the GENERAL page Device >status reads, "This device cannot start (Code 10)". >Then another line says to click Troubleshooter, but doing so gives me a blank in >troubleshooter. I put in some topics but to no avail. I've tried everything I can >think of. I even bought another modem and it does the same thing. I'm at a lost. >Anyone come up on this, if so what did you do to fix it? Written in response to: Modem canot start (Code 10) (John McMurtry: Saturday, April 3, 2004 at 11:16 am) Responses to this message: re: Modem canot start (Code 10) (John McMurtry: Saturday, April 3, 2004 at 1:20 pm) All messages in this thread [show all] Modem canot start (Code 10) (John McMurtry: Sat, Apr 3, 2004, 11:16 am) re: Modem canot start (Code 10) (J.R.: Sat, Apr 3, 2004, 12:02 pm) re: Modem canot start (Code 10) (triplate: Sat, Apr 3, 2004, 12:05 pm) re: Modem canot start (Code 10) (John McMurtry: Sat, Apr 3, 2004, 1:20 pm) re: Modem canot start (Code 10) (jaf: Sat, Apr 3, 2004, 1:36 pm) re: Modem canot start (Code 10) (John McMurtry: Fri, Apr 9, 2004, 10:38 pm) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows XP Discussion Forum