re: Modem canot start (Code 10) Saturday, April 3, 2004 at 1:36 pm Windows XP Annoyances Discussion Forum Posted by jaf (3408 messages posted) Check which com port your modem is assigned to then enter your bios setup and make sure that port is activated. On Saturday, April 3, 2004 at 11:16 am, John McMurtry wrote: >I have just done a new install of XP on a blank Hard Drive. All is well except the >modem which will not work. In Device Manger it shows it has a problem with the "!" >in a yellow diamond next to the item. Checking the properties, the GENERAL page Device >status reads, "This device cannot start (Code 10)". >Then another line says to click Troubleshooter, but doing so gives me a blank in >troubleshooter. I put in some topics but to no avail. I've tried everything I can >think of. I even bought another modem and it does the same thing. I'm at a lost. >Anyone come up on this, if so what did you do to fix it? Written in response to: Modem canot start (Code 10) (John McMurtry: Saturday, April 3, 2004 at 11:16 am) There are presently no replies to this message. All messages in this thread [show all] Modem canot start (Code 10) (John McMurtry: Sat, Apr 3, 2004, 11:16 am) re: Modem canot start (Code 10) (J.R.: Sat, Apr 3, 2004, 12:02 pm) re: Modem canot start (Code 10) (triplate: Sat, Apr 3, 2004, 12:05 pm) re: Modem canot start (Code 10) (John McMurtry: Sat, Apr 3, 2004, 1:20 pm) re: Modem canot start (Code 10) (jaf: Sat, Apr 3, 2004, 1:36 pm) re: Modem canot start (Code 10) (John McMurtry: Fri, Apr 9, 2004, 10:38 pm) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows XP Discussion Forum