>
>I have tried running the "new" CHKDSK under Windows XP using both the Error Checking
>tool in "My Computer/File/Properties" and from the command line.
>
>When I used the Error Checking tool (without selecting the Automatic fix of file
>system errors or the scan for bad sectors) XP displayed a dialogue with a sequence
>of messages, telling me that the Error Checker was performing phase 1 of its check,
>then phases 2 and 3 and finally a new dialogue appeared telling me that the check
>had been completed - and nothing more.
>
>When I ran CHKDSK from the command prompt, using the command "CHKDSK C: /V" the output
>was more informative:
>
>"The type of the file system is NTFS.
>
>WARNING! F parameter not specified.
>Running CHKDSK in read-only mode.
>
>CHKDSK is verifying files (stage 1 of 3)...
>File verification completed.
>CHKDSK is verifying indexes (stage 2 of 3)...
>Index verification completed.
>Detected minor inconsistencies on the drive.
>CHKDSK is verifying security descriptors (stage 3 of 3)
>Cleaning up 33 unused index entries from index
>Cleaning up 33 unused index entries from index
>Cleaning up 33 unused security descriptors.
>Security descriptor verification completed.
>CHKDSK is verifying Usn Journal...
>Usn Journal verification completed.
>Correcting errors in the Volume Bitmap.
>Windows found problems with the file system.
>Run CHKDSK with the /F (fix) option to correct"
>
>My question is, which should I trust - the Error Checking tool (which I assume invokes
>CHKDSK in the background) or the command line? Or perhaps a third party program?

Written in response to: Question about 'Prevent file corruption problems' (Paul: Friday, October 4, 2002 at 10:02 pm) There are presently no replies to this message.

• Reply or follow-up to this message

• Search this forum
• Start a new thread on a different subject

• Report abuse of the forum